Wall Mount Box for Single Controller 10x8x6"

Starting at: $49.90  $35.00
Save: $14.90 off


  • Model: B252015
  •  
     



    Qty.

    Please Choose:










Product Description:

Overstock sale! While supplies last!

Note: Scratch & Dent box are available for limited models. Please check here.

This controller enclosure measures 10 x 8 x 6" (250 x 200 x 150 mm).  A 1/16 or 1/4 DIN sized controller can be installed with adequate room for wiring and switching device. The box is made of powder coated, 0.040" (1 mm) thick steel. One side of the wall has a pre-cut opening. It can be used for installing cables or heat sink. The door comes with lock and key. The hinge of the door are removable. It can be installed on either right or left side. This allows the user put the pre-cut opening either on top or at the bottom without changing the door opening directions.  Gasket and plugs are provided. It is rated for IP65 before any wholes are cut. The enclosure is designed to be mounted on a wall. You can directly mount it with screws or hang it on the wall with the optional hangers. For high power circuit, wall mount box is preferred because the heavy cords (14 AWG or thicker) are difficult to manage with a table top enclosure. 
 
 The box has a pre-cut hole on the top for external heatsink. If you are going to use SSR instead of contactor as the switching device, you can order the optional external mounted heat sink. The external mounted heat sink eliminates the venting requirement of the enclosure for internally mounted heat sink. It is more efficient and keeps the internal of the controller box free from the dust. Two different sizes of heat sink are offered, 40 A and 60A. The 40A heat sink is about  the 1 inch narrower and 1/4" shorter. Both heat sink come with pre-drilled and tapped mounting holes for the box and SSR. 60A heat sink has mounting holes for two SSRs. Mounting screws and thermal conductive grease are included. There is no need to cut for installing the heat sink. Please select the heat sink size option when ordering. 

A option of factory precut hole for 1 x 1/16DIN controller is also offered.  It will save a lot of headache for most users that don't have the special tool to cut it.  User needs to cut some round holes for switches and connectors. But round shaped holes are much easier to cut on the sheet metal than the square holes are.

Click here for the part list of WSD-SMD smoker controller.


Box with 60A Heatsink and Controller Installed
 


Internal View, with 2 SSRs Intalled on 60A Heatsink


Internal View, with SSR Intalled on 40A Heatsink



Top View, without Heatsink Installed



Optional Hanger


How to mount two SSRs on BHS60A heat sink 



This product was added to our catalog on Thursday 18 July, 2013.

Copyright © 2017 auberins.com. Contact sales@auberins.com